- Modern Bathroom Furniture – practical ideas for vanity
- 14 Balcony ideas – with flower boxes decorate the railings
- Luxury Villa in Thailand, surrounded by woods and rocks
- Ethno-mask on the bed
- Desk with drawers design office Inside Cosimo
- Eco-Friendly Pool Designs – Solar heating and bio-filter
- Design chairs in candy colors
- Rustic Coffee Table
- Design ideas and essential items for the outdoor dining area
- Sofa with a coffee table in the living room
Swinging build it yourself wood – User
A sitting area around the fireplace in the garden - so that it can describe the construction project faster. At Hexagon design not one but five wooden swing attached. Do not be fooled - this can be difficult and tedious at first glance, is actually a weekend project.
Wooden swing - materials for the construction project
For the weekend project - wooden swing, you will need the following documents:
- Batteries Support / 6 Rooms / - 3 feet tall, 6 wooden beams for the roof construction / lower Hexagon / - 2.40 meters long, 6 wooden beams for the roof / upper hex / - 2:08 meters long, swings, are more than 1.80 meters wide.
Bolt - you may be better advised to hardware so you can choose the appropriate attachment to wood.
For this project, you need the help of at least one technically gifted friend.
Wooden swing - Instructions
Select the first position of the party - the field must be no tilt. Then mark the correct position of the back-up batteries / 2.4 meters / remote, dig holes, set the level of vertical poles / surveyor, you can again test the safety, if they are really only /. Stabilize the position with wood construction / s.Foto /. Then you can use concrete piles. Note that the wooden structure which stabilizes the position is always present. Ready for Day 1
Day. 2 - the second day, the roof structure is built. First, all bearing piles with six wooden beams / 2:40 lang / connect / s.Foto /. Now, the stabilizer may have already been deleted. The second hexagon is constructed from short beams 6 / 2.08 meters / and connecting the centers of the beams more. This is necessary because otherwise the structure is not supported 5 oscillations.
Once the pattern is established, the switch can be solved. Then all the pieces of wood should be painted or deleted. If you want, you can make a bowl of open fire in the middle - in this case just cover the area with an anti-algae and then spread the gravel on the ground.
The construction of the roof structure
The first wooden beams connecting posts
The second beams also form hexagon and connect the centers of the first
When the construction was completed, the fireplace can be built
At the end of the wood is painted - and you're done!